ST Access Floor System – Get the Best from Bates Interior Solutions

Supplied and installed by Bates Interior Solutions, the ST access floor system is in widespread demand for overhauling office floorings. Bates ensures proper installation of these floor systems to make them rigid, firm, and free from any shaky movement or rocking panels. 


Moreover, several noises audible from the floor due to movement or any other factor contribute adversely to the acoustic properties of the area. You will find the ST access floor system free of such odd noises. Here is more on this branded product:

Component specification

The panels resemble higher-dimensional precision and panel strength due to several crucial factors:

·       Four corner solid and self-locating locking system

·       18 convex salient point structure for enhanced load capacity

·       International dome design for an elegant appearance

·       Corrosion-protected interior and exterior surfaces

·       Non-combustible cementitious compound contained in the core

·       Epoxy-coated exterior panels

Welded to a deep drawing steel bottom section of the domed formation, these floor panels are:

·       Linear and rigid

·       Fabricated from non-combustible components

·       Made of high-hardness top steel sheet

 Types of ST access floor systems

 These access floor solutions are available in freestanding, Snap-On Stringer, Bolt-On Stringer, and Screw-Down System, respectively. Here is the detailed description:

1. Freestanding system

All four corners of the flooring panels rely on an aluminum head consisting of a PVC gasket for noise reduction. The head gets support from a corrosion-protected steel base. The best thing is that this access floor system is fully functional without screws.

2. Snap-on stringer system

This ST Access floor system accompanies a pre-assembled rubber gasket to minimise noise transfer from the floor panel to the room. The installation is simple. All you need is to open the panels and clip the steel Snap-On stringer on the head of the pedestal. Removing the stringers is easy due to the positive placement of the access floor panel on the aluminum head. You can remove them without losing the lateral stability of the access floor system.

3. Bolt-On stringer system

This system uses a steel flat head along with tapped and drilled holes to accommodate the bolt-on stringer tube, along with a rubber gasket. Best for use in places requiring higher load capacity.

4. Screw-down system

Finally, these ST access floor systems comprise four corrosion-resistant fasteners to tighten the panel and mechanically fix it to the pedestal heads. Removing the panel is simple, as you only need to release the fasteners without losing the lateral stability of the floors.

Learn more about these access floor systems at Bates Interior Solutions. The brand is the supplier and installer of industry-best raised floor systems, including ST access floors.

Comments

Popular posts from this blog

Access Vs Traditional Flooring: The Better Option for Commercial Spaces

The Importance of Quality Carpeting and Flooring in Office Design

Bates Interior Solutions: Your Ultimate Destination for Access Flooring Accessories